Download For convenience this document uses short names when referring to a particular system or kit. The list below identifies the short names used herein: Remote Start System with Deluxe Vehicle Security and Keyless Entry —> RKE/VSS/RMST Remote Start System with Keyless Entry —> RKE/RMST Remote Start System —> RMST Deluxe Vehicle Security System with Keyless Entry —> Deluxe RKE/VSS Vehicle Security System with Keyless Entry —> RKE/VSS Vehicle Security System for Vehicles Equipped with Factory Keyless Entry —> VSS Keyless Entry System —> RKE. MODULE PREP A RATION Place the supplied fuses into the power distribution block on the control module. Refer to the fuse placement drawing for the specific vehicle that you are working on. Fuse placement drawings are located in vehicle specific wiring sections. In this diagram, the parking light fuse is shown in the positive polarity position and the Dome light fuse is shown in the negative polarity position. Note: The HVAC1, HVAC2 and IGNITION fuses are only used on systems including remote car start (requires PC-32 module). Place the software cartridge (DNA) onto the control module as shown. Plug the wiring harness(es) into the module. Harness A: 24-way, used on all systems; Harness B: 10-way, used on all systems with car start; Harness C: 16-way, used on systems with convenience features (i.e. Headlight control, memory seat control) along with some preload system installations in vehicles without factory equipped RKE. If you are installing a system that uses the whip antenna (RKE, RKE/VSS or Preload), plug the whip antenna into the module at this time. Referring to the vehicle specific wiring section for the system being installed, gather all individual wires that will be routed to the same areas of the vehicle into groups. Cover each wire group with tape for approximately 18″. Depending upon the vehicle, there will be 2 – 5 different wire groups. Trim the unused wires approximately 6 – 8″ from the module. Do not cut the override/programming button off of the harness, it is used for all installations. VEHICLE PREP A RATION All models except LS, T-Bird, Escort, Econoline and Super-Duty Pick-ups, remove the steering column shroud to allow access to the PATS transceiver antenna ring around the ignition switch lock cylinder. A. To allow access to the necessary vehicle circuits, remove the interior panels as required. B. Identify the control module mounting location and appropriate vehicle circuit connection points. Plan wire harness routings that will be free and clear of all moving underdash components (i.e. accelerator pedal, adjustable position brake pedal assembly and parking brake mechanism.
The post 2002 FORD-KEY INSTALLATION INSTRUCTIONS AND TECHNICAL REFERENCE MANUAL appeared first on ToManual.com.
